serial updating question

[Neerav Patel]

Hi,

So I managed to get it to send data and write to flash, but now the flash isn't really booting into the U-Boot prompt.  What address should the UBL and U-Boot be written to, in the flash?

Thanks in advance.

Neerav

-----Original Message-----
From: Neerav Patel 
Sent: Tuesday, December 09, 2008 9:13 AM
To: 'Griffis, Brad'; davinci-linux-open-source at linux.davincidsp.com
Subject: RE: serial updating question


Hi,

I am using Linux and everything is installed, including mono.  I can run the program and everything, it just stops at "Sending UBL..."

Neerav

-----Original Message-----
From: Griffis, Brad [mailto:bgriffis at ti.com] 
Sent: Tuesday, December 09, 2008 6:55 AM
To: Neerav Patel; davinci-linux-open-source at linux.davincidsp.com
Subject: RE: serial updating question

If you're using Windows, do you have .Net Framework 2.0 installed?  If you're using Linux did you install mono?

Brad

> -----Original Message-----
> From: Neerav Patel [mailto:Neerav.Patel at ptgrey.com]
> Sent: Monday, December 08, 2008 4:43 PM
> To: Griffis, Brad; davinci-linux-open-source at linux.davincidsp.com
> Subject: RE: serial updating question
> 
> 
> Hi,
> 
> When I check the UART, it is constantly sending out a BOOTME command.
> When I tried sending the sfh command out again it went through but then
> stopped at "Sending the UBL..."  Do I have to do something else?
> 
> Thanks
> 
> Neerav
> 
> 
> -----Original Message-----
> From: Griffis, Brad [mailto:bgriffis at ti.com]
> Sent: Monday, December 08, 2008 1:28 PM
> To: Neerav Patel; davinci-linux-open-source at linux.davincidsp.com
> Subject: RE: serial updating question
> 
> Is your board setup for UART boot such that it's spewing out "BOOTME"?  If
> not, there's no way for the utility to download itself to the device.
> 
> Brad
> 
> ________________________________________
> From: davinci-linux-open-source-bounces at linux.davincidsp.com
> [mailto:davinci-linux-open-source-bounces at linux.davincidsp.com] On Behalf
> Of Neerav Patel
> Sent: Monday, December 08, 2008 2:39 PM
> To: davinci-linux-open-source at linux.davincidsp.com
> Subject: serial updating question
> 
> Hi,
> 
> I recently got some new NAND Flash for the DM355 EVM.  I want to download
> Montavista image that I compiled on the host side using the Getting
> Started Guide.  I was told to use this
> http://wiki.davincidsp.com/index.php?title=Serial_Boot_and_Flash_Loading_U
> tility utility, so I compiled this and ran it, and no matter what I do it
> stops at "Waiting for the DM35x.".  The simple command that I typed in the
> shell was "mono sfh_DM35x.exe -nanderase"
> 
> I tried to use the command that will allow me to download the image to the
> flash, but that did the same thing?
> 
> Any help would be greatly appreciated!
> 
> Neerav